Quick Reference Guide 5
PRESS
DURATION
FUNCTION COMMENT
Momentary
(when scanner is
asleep)
Wakes scanner from
Sleep Mode
Alternatively, the scanner can
be awakened by:
- Moving an object through the
scan zone.
- Scanning with an attached
auxiliary scanner.
Momentary
(when scanner is
awake)
Increments volume
Press the button momentarily
to increase speaker volume.
When the loudest volume is
reached, a repeated press of
the button cycles volume back
to the lowest setting, then vol-
ume increases on subsequent
press(es). Five volume levels
are available.
Hold, then
release when the
beeper sounds
Increments tone
Press the button for approxi-
mately 2 seconds, then release.
Each time this is done, the
beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
4 Seconds
Scanner Diagnostics
Mode
a
This mode allows system sup-
port personnel to troubleshoot
problems with the scanner and
is used to determine if it can
read bar codes. Press the but-
ton for 8 seconds or cycle
power to exit Scanner Diagnos-
tics Mode and reset the scan-
ner.
8 Seconds Resets Scanner
b
Only system support person-
nel should perform a reset.
a. By standard default, this function is normally disabled to prevent
accidental activation by users.
b. Users should not perform scanner resets except under the direction
of trained systems support personnel.
To Next Page
Loading...
Need help?
General