7.6.3 Restore Factory Defaults
In order to return a device to its absolute Factory default parameters (for example device
replacement) it is necessary to use the Restore Factory Defaults command. You will be
prompted to confirm.
All Environment parameters will be restored to Factory default values and any existing
configurations stored on the device will be erased. The device will be reset and therefore
start in run mode with the factory default configuration.
7.7 DIAGNOSTIC ALARMS
By using the DL.CODE Monitor functions from the File menu (or Monitor icon), you can get
information about the state of the reader.
Figure 68 - Diagnostic Alarms
To Next Page
Loading...
