Datalogic Matrix 120 - Step 4 - Installing DL.CODE Configuration Program

RAPID CONFIGURATION
9
1
STEP 4 – INSTALLING DL.CODE CONFIGURATION PROGRAM
DL.CODE is a Datalogic reader configuration tool providing several important advantages:
 Intuitive Graphical User Interface for rapid configuration;
 Defined configuration directly stored in the reader;
 Discovery and IP address setting features to facilitate remote configuration
 Device Monitoring
 Device Driver Installation
To install DL.CODE:
1. On the PC that will be used for configuration, (running Windows XP SP3, 7, 8, or 10),
download the DL.CODE mini-DVD .zip file. Extract the files maintaining the folder structure
and run the start.hta file to access the installation pop-up. Click on the Install DL.CODE link
to run the installation program and follow the installation procedure.
NOTE: To configure Serial + USB model devices, check the appropriate
Matrix USB Driver and/or RS232 Serial Port Driver installation boxes in the
Welcome window of the DL.CODE Installer. In this case it is recommended to
reboot the PC after DL.CODE installation.
2. When the installation is complete the DL.CODE entry is created in the Start>Programs
bar under “Datalogic” as well as a desktop icon. Double-click the desktop icon to run it.
Depending on your Matrix 120 model, you can connect to the DL.CODE configuration
environment through one of the following interfaces:
Model
Interface
Instructions
Matrix 120 xxx-x1x
Ethernet Configuration
STEP 4A
Matrix 120 xxx-x0x
USB Configuration
STEP 4B
All
Serial Configuration *
STEP 4C
* All devices can be configured through their Main Serial port. However, through this
interface, configuration is slower than the Ethernet or USB interfaces and presents some
limitations. It is recommended to use the Serial interface for configuration only if the
other interfaces are not available.