Datalogic Matrix 120 - Serial Connection

TYPICAL LAYOUTS
61
5
5.2 SERIAL CONNECTION
In this layout the data is transmitted to the Host on the main serial interface. The Ethernet
interface can be used for reader configuration by connecting a laptop computer running
DL.CODE.
Data can be transmitted on the RS232 auxiliary interface independently from the main
interface selection to monitor data.
When One Shot or Phase Mode operating mode is used, the reader can be activated by an
External Trigger (for example a pulse from a photoelectric sensor) when the object enters its
reading zone.
Figure 50 – Serial Interface Point-to-Point Layout
All devices always support multiple output channels (i.e. for data monitoring).
 Main Serial Interface (RS232 or RS422 Full-Duplex)
 Optional outputs
 External Trigger (for One Shot or Phase Mode)
Matrix 120
1
2
3
Host
CBX
CAB-1011
10-30 Vdc
External Power for Matrix 120
and I/O Accessories