Datalogic Matrix 120 - X-PRESS Human Machine Interface; X-PRESS Functions

MATRIX 120™ REFERENCE MANUAL
30
2
2.3 X-PRESS HUMAN MACHINE INTERFACE
X-PRESS is the intuitive Human Machine Interface designed to improve ease of installation
and maintenance.
Status information is clearly presented by means of the five colored LEDs, whereas the
single push button gives immediate access to the following relevant functions:
Test Mode with bar graph visualization to check
static reading performance.
Focus (Aim) turns on the laser indicator to aim the
reader at the target. The target should be placed
a few mm to the left and centered vertically with
respect to the aiming pattern (cross).
Setup to self-optimize and auto-configure
photometry parameters.
Learn to self-detect and auto-configure for reading
an unknown barcode (by type and length). Only
one symbology type can be saved using this
method. Performing Autolearn on a second
symbology will overwrite the first one.
2.3.1 X-PRESS Functions
Quick access to the following functions is provided by an easy procedure using the push
button:
1 – Press the button (the Status LED will give a visual feedback).
2 – Hold the button until the specific function LED is on (Test, Focus/Aim, Setup or Learn).
3 – Release the button to enter the specific function.
Once button is pressed, the cycle of LEDs activation is as follows:

Release button
to Exit

Release button
to enter Test Mode

Release button
to enter Focus/Aim Mode

Release button
to enter Setup Mode

Release button
to enter Learn Mode
 (cycle)
Release button
to Exit