Datalogic PowerScan D8330

Enter Configuration
Exit and Save Configuration
Ì$+;Î
16-KEY DK MODEL PARAMETERS
Ì$-?Î
152
TERMINATOR

no terminator
one character terminator
two character terminator


three character terminator
four character terminator


five character terminator
six character terminator


seven character terminator
eight character terminator


After selecting one of the desired Header codes, read the character(s) from the HEX table.
Valid characters are in the range 00-FE. For Wedge and USB-KBD interfaces, it is also possible
to read the Special Key(s) on page 74.
Example:
Two character terminator Hex codes Terminator
Read +
0D + 0A
=
CR LF
For more details see par. 5.4.1 and par. 5.4.2. See also “Message Formatting” in par. 6.1 and
par. 6.2.