48 PowerScan
®
RF Scanner
RF Beeper
Volume
The volume at which the beeper sounds for ACK, transmission error,
link, or unlink beeps (but not the good read beep
1
) are all affected by
this setting. Select volume #1 (25% duty cycle), volume #2 (35% duty
cycle), or volume #3 (50% duty cycle).
Feature is specific to scanner ONLY
1. Good read beep volume is selectable via the features available in the PowerScan Programming
Manual (P/N R44-1840). See References for information about acquiring other manuals.
SET -------------------------------------------
RF Beeper Volume #1
RF Beeper Volume #2
RF Beeper Volume #3
END ------------------------------------------
To Next Page
Loading...
