Datalogic QuickScan QBT2400 Quick Reference Guide

Scan Modes
30 QuickScan™ QBT2400
Pick Mode
Pick Mode is a Decoding and Transmission process where bar
codes that are not within the configurable distance from the
center of the aiming pattern are not acknowledged or trans-
mitted to the host. It is active only while the scanner is in
Trigger Single mode. If the scanner switches to a different
Read Mode, Pick Mode is automatically disabled.
Multiple Labels in a Volume
Enables/disables the ability of scanner to decode multiple
labels in the same image. Several programming options are
available for this feature, see the PRG for more information.
NOTE
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG for
more information.
PICK MODE
ENTER/EXIT PROGRAMMING MODE
♦ Pick Mode = Disable
Pick Mode = Enable

Datalogic QuickScan QBT2400 Specifications

General

Connectivity	Bluetooth
Battery Type	Lithium-Ion
Battery Capacity	1400 mAh
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Interfaces Supported	USB, RS-232, Keyboard Wedge
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Radio Range (Open Air)	100 m
Type	Handheld
Scan Rate	60 frames per second
Resolution	0.1 mm
Humidity	5 to 95% non-condensing
Light Source	Red LED
Supported Barcodes	1D / 2D and postal codes