Datalogic QuickScan QD2430 User Manual

Reading Parameters
16 QuickScan™ QD2430
Reading Parameters
Move the reader toward the target and center the aiming pat-
tern and illumination system to capture and decode the
image. See Using the Quickscan™ QD24XX on page 3 for more
information.
The aiming system will briefly switch off after the acquisition
time, and if no code is decoded will switch on again before the
next acquisition. The illuminator will remain on until the sym-
bol is decoded.
As you read code symbols, adjust the distance at which you
are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the QuickScan QD24XX PRG for
more information and programming bar codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green spot.
Use the bar codes that follow to specify the duration of the
good read pointer beam after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Disabled
♦ Short (300 ms)
Medium (500 ms)
Long (800 ms)

Datalogic QuickScan QD2430 Specifications

General

Scanner Type	2D Area Imager
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Motion Tolerance	25 IPS
Ambient Light	0 - 100, 000 lux
ESD Protection (Air Discharge)	16 kV
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Humidity (Non-Condensing)	5 - 95%
Light Source	Red LED
Resolution	0.1 mm (4 mil)
Interface	USB, RS-232, Keyboard Wedge
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Weight	145.0 g / 5.1 oz
Image Sensor	752 x 480 pixels
Decode Capability	1D / Linear Codes, Stacked Codes, 2D Codes, Postal Codes
Reading Angle	Pitch: +/- 65°, Roll: 360°, Skew: +/- 60°
Power Supply	5 VDC +/- 5%