LED and Beeper Indications
Quick Reference Guide 25
Programming Mode
-
The following indications ONLY occur
when the reader is in Programming Mode
.
INDICATION DESCRIPTION LED BEEPER
Label Programming
Mode Entry
A valid programming label
has been scanned.
LED blinks contin-
uously
Reader sounds four
low frequency beeps.
Label Programming
Mode Rejection of
Label
A label has been rejected. N/A
Reader sounds three
times at lowest fre-
quency and current
volume.
Label Programming
Mode Acceptance of
Partial Label
In cases where multiple
labels must be scanned to
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully scanned.
N/A
Reader sounds one
short beep at highest
frequency and cur-
rent volume.
Label Programming
Mode Acceptance of
Programming
Configuration option(s)
have been successfully pro-
grammed via labels and
the reader has exited Pro-
gramming Mode.
N/A
Reader sounds one
high frequency beep
and 4 low frequency
beeps followed by
reset beeps.
Label Programming
Mode Cancel Item
Entry
Cancel label has been
scanned.
N/A
Reader sounds two
times at low fre-
quency and current
volume.
To Next Page
Loading...
