Datalogic QuickScan QD2430 User Manual

Cleaning
Quick Reference Guide 27
Cleaning
Exterior surfaces and scan windows exposed to spills,
smudges or debris require periodic cleaning to ensure best
performance during scanning.
Use a soft, dry cloth to clean the product. If the product is very
soiled, clean it with a soft cloth moistened with a diluted non-
aggressive cleaning solution or diluted ethyl alcohol.
CAUTION
Do not use abrasive or aggressive cleansing
agents or abrasive pads to clean scan windows
or plastics.
Do not spray or pour liquids directly onto the
unit.

Datalogic QuickScan QD2430 Specifications

General

Scanner Type	2D Area Imager
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Motion Tolerance	25 IPS
Ambient Light	0 - 100, 000 lux
ESD Protection (Air Discharge)	16 kV
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Humidity (Non-Condensing)	5 - 95%
Light Source	Red LED
Resolution	0.1 mm (4 mil)
Interface	USB, RS-232, Keyboard Wedge
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Weight	145.0 g / 5.1 oz
Image Sensor	752 x 480 pixels
Decode Capability	1D / Linear Codes, Stacked Codes, 2D Codes, Postal Codes
Reading Angle	Pitch: +/- 65°, Roll: 360°, Skew: +/- 60°
Power Supply	5 VDC +/- 5%