Datalogic QuickScan QD2430 User Manual

Error Codes
26 QuickScan™ QD2430
Error Codes
Upon startup, if the reader sounds a long tone, this means the
reader has not passed its automatic Selftest and has entered
FRU (Field Replaceable Unit) isolation mode. If the reader is
reset, the sequence will be repeated. Press and release the
trigger to hear the FRU indication code.
The following table describes the LED flashes/beep codes
associated with an error found.
Number
of LED
Flashes/
Beeps
Error Corrective Action
1 Configuration
Contact Helpdesk for assis-
tance
2Interface PCB
6 Digital PCB
11 Imager

Datalogic QuickScan QD2430 Specifications

General

Scanner Type	2D Area Imager
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Motion Tolerance	25 IPS
Ambient Light	0 - 100, 000 lux
ESD Protection (Air Discharge)	16 kV
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Humidity (Non-Condensing)	5 - 95%
Light Source	Red LED
Resolution	0.1 mm (4 mil)
Interface	USB, RS-232, Keyboard Wedge
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Weight	145.0 g / 5.1 oz
Image Sensor	752 x 480 pixels
Decode Capability	1D / Linear Codes, Stacked Codes, 2D Codes, Postal Codes
Reading Angle	Pitch: +/- 65°, Roll: 360°, Skew: +/- 60°
Power Supply	5 VDC +/- 5%