Datalogic QuickScan QD2430 User Manual

Operating Modes
Quick Reference Guide 19
Pick Mode
Specifies the ability of the reader to decode labels only when
they are close to the center of the aiming pattern, which is the
area indicated by the two blue arrows. Pick Mode is a Decod-
ing and Transmission process where bar codes that are not
within the configurable distance from the center of the aiming
pattern are not acknowledged or transmitted to the host. It is
active only while the scanner is in Trigger Single mode. If the
scanner switches to a different Read Mode, Pick Mode is
automatically disabled.
Multiple Label Reading
The reader offers a number of options for multiple label read-
ing. See the PRG or software configuration tool for descrip-
tions of these features and programming labels.
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG for
more information.
PICK MODE
ENTER/EXIT PROGRAMMING MODE
♦ PIck Mode = Disable
Pick Mode = Enable

Datalogic QuickScan QD2430 Specifications

General

Scanner Type	2D Area Imager
IP Rating	IP42
Print Contrast Ratio (Minimum)	25%
Motion Tolerance	25 IPS
Ambient Light	0 - 100, 000 lux
ESD Protection (Air Discharge)	16 kV
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-40 to 70 °C / -40 to 158 °F
Humidity (Non-Condensing)	5 - 95%
Light Source	Red LED
Resolution	0.1 mm (4 mil)
Interface	USB, RS-232, Keyboard Wedge
Drop Resistance	Withstands drops from 1.5 m / 5.0 ft
Weight	145.0 g / 5.1 oz
Image Sensor	752 x 480 pixels
Decode Capability	1D / Linear Codes, Stacked Codes, 2D Codes, Postal Codes
Reading Angle	Pitch: +/- 65°, Roll: 360°, Skew: +/- 60°
Power Supply	5 VDC +/- 5%