92 M-Class
If experiencing this problem…
Try this solution…
Poor print quality:
The printhead may need cleaning; see Section 6.1.
Adjust the Heat and Print Speed settings through the Front Panel or by host
commands; non-display printers see Section 4.5.2, display printers see Section
5.1.3.
The media/ribbon combination may not be compatible; contact a Media
Representative.
The Printhead Leveling Cam may be incorrectly adjusted; see Section 6.2.
The Platen Roller may be dirty or worn; clean or call for service.
The Printhead Burn Line may need adjusting; see Section 6.3.
Skips labels when printing:
Media Calibration may be needed; non-display printers see Section 4.7, display
printers see Section 5.4.
The Media Sensor may be out of position; readjust the position; see Section 3.3.
The format may be within 1/8 inch of the label’s trailing edge. Try reducing or
moving the format slightly.
Unable to print rotated text:
The characters may be formatted outside the label dimensions. Ensure the
row/column values provide enough room for the height of the characters or bar
code to be printed. See the Class Series Programmer’s Manual for details.
To Next Page
Loading...
