76 M-Class
Advanced Entry Calibration (continued)
Step Operator Action Displayed Message Comment
13
Using the
FWD
Key, select
the Gain Number determined
in Step 12. Press the
Key to select the setting.
!
HBJO!USBO!!!!!!=zzz?+1
9!!!!!!!!!)1!.!42*!
!
Or, for reflective media:
HBJO!SFGM!!!!!!=zzz?+1
9!!!!!!!!!)1!.!42*!
Selection is denoted with an ‘*’.
14
Place the media in the Media
Sensor. Record the sensor
reading and label it ‘P’
(paper).
Place the backing, mark, or
notch in the Media Sensor.
Record the sensor reading
and label it ‘G’ or ‘M’ (Gap
or Mark).
Remove all media. Record
the sensor reading and label
it ‘E’ (Empty).
!
HBJO!USBO!!!!!!=zzz?+1
9!!!!!!!!!)1!.!42*!
!
Or, for reflective media:
HBJO!SFGM!!!!!!=zzz?+1
9!!!!!!!!!)1!.!42*!
Where ‘yyy’ is a numerical value representing the
current sensor reading.
15
Press the
Key. Then
press the
FWD
Key.
!
BEWBODFE!FOUSZ!
TFOTPS!MFWFMT!
!
The sensor readings must be manually entered into
the printer now.
To Next Page
Loading...
