Datcon DT9502 - Page 21

DT9502
20171205-V3
21
Messages of critical
errors

A/D failure (Service: AD Hardware)

EEPROM failure (Service: EEPROM Hardware)

EEPROM write error (Service: EEPROM Protected)

Calibration error (Service: Calibration)

Default factory settings (Service: Default Factory
Settings)

The last saving was not successful (Error: Last Save)
During code writing

Code? (Code)

Bad Code (Bad Code)

A User login took place (User)

A Supervisor login took place (Supervisor)
During setting up

The typed number is lower than allowed (Low Limit)

The typed number is higher than allowed (High Limit)

Low numeric value not possible to display

High numeric value not possible to display

Re-type it please. (Re-type)

Automatic escaping (Auto Escape) - after 1 minute

Exit from the setting (Exit)

The instrument is making calculations, please wait
(Busy)

The requested operation has been completed ( (Ready)

The saving of the settings is being done (Save)

No, I don’t want this menu (No)

Yes, the menu can be started (Yes)