Datcon DT9502 - Display Refresh Time (08. Menu Item)

DT9502
46 20171205-V3
7.10. Display refresh time (08. menu item)
Function The instrument performs cca. 15 measurements in each
seconds. It’s too fast to see the changing of the
measurement value.
Here you can define the time periods by which the
instrument displays the new measurement values.
[Default factory setting: 0.5 second]
Sequence of operations 1. Enter the menu by pressing a supervisor code.
The way the code should be type in is described in Chapter
7.1. Type the code in. You see on the display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
.
3. Enter the menu item by pressing the ENTER button.
4. You see this
 on the display. It’s meaning: 0.5
seconds) The 0.5 numerical value is blinking.
5. Pressing the ▲ button select the time periods by which
the instrument should display the new measurement values.
• = once in each 0.5 seconds [Default factory
setting].
• = once in each 1 second.
• = once in each 1.5 seconds.
• = once in each 2 seconds.
• = once in each 0.1 seconds.
• = once in each 0.3 seconds.