DT9502
20171205-V3
45
Sequence of operations
• : The displayed value is the same as the last
measurement result; the previous measurements do not
influence this value.
(The display settling time after the stabilisation of the input
signal: 0.1 second.)
• : The displayed value is the average of the last 2
measurements.
(The display settling time after the stabilisation of the input
signal: 0.1 second.)
• : The displayed value is the average of the last 4
measurements.
(The display settling time after the stabilisation of the input
signal: 0.3 seconds.)
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
from the menu item, and you see this:
.
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. If you don’t want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
(Exit) are shown on the
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
To Next Page
Loading...