Datcon DT9502 - Disable Displaying the Leader Zeros (13. Menu Item)

DT9502
20171205-V3
57
7.15. Disable displaying the leader zeros
(13. menu item)
Function Leader zero: the zeros that stand before an integer of no
value. E.g. the instrument displays the value 5.2 together
with the leader zeros:
 (default factory setting), or without the leader
zeros:
.
In this menu item you can either disable displaying of the
leader zeros, or you can enable this function again.
Sequence of operations 1. Enter the menu by typing a supervisor code.
The way the code should be type is described in Chapter
7.1. Typing the code in. You see on the display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
.
3. Enter the menu item by pressing the ENTER button.
4. You see this
 on the display. The text is blinking.
5. You may switch between the two operating modes by
pressing ▲ button.
• = the leader zeros are shown on the display
(default factory setting).
• = the leader zeros are not shown on the display.
Comment: one zero directly before the decimal point is
always shown on the display.
Exit from the menu item 1. After you have performed the setting, press the MENU
button. This takes you out from the menu item, and you see
this:
.
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. If you do not want to exit from the menu because you
want to perform other settings too, you may press the ▲
button to select the desired menu item.)