DT9502
20171205-V3
55
7.14. Display operating modes (12. menu item)
Function The instrument has a 4-and-a-half-digit display. It is
possible to switch it into a 3-and-a-half-digit display mode.
In this case the display behaves like a 3-and-a-half-digit
display during measurement. (The mnemonics are
displayed in four digits).
[Default factory setting: four-and-a-half-digit operating
mode.]
Sequence of operations
1. Enter the menu by typing a supervisor code.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see on the display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
.
3. Enter the menu item by pressing the ENTER button.
4. You see this
on the display. The mnemonic is
blinking.
5. You may switch between the two operating modes by
pressing ▲ button.
• = four-and-a-half-digit operating mode [Default
factory setting]
• = three-and-a-half-digit operating mode
In the three-and-a-half-digit operating mode the possible
range of numbers to display is reduced to the values being
between -200.0 and 200.0.
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
from the menu item, and you see this:
.
(2. If you want to change the setting you have performed
just now, or if you just want to check what you have typed
in, continue the operation from Point 3 of the Sequence of
operations.)
(3. If you do not want to exit from the menu, as you want to
perform further settings, you may press the ▲ button to
select the desired menu items.)
To Next Page
Loading...