DT9502
70 20171205-V3
10.6. Messages and error messages during setting up
The following mnemonics may displayed when the settings
are being performed.
The value you have defined is lower than permissible
(Low Limit)
The instrument has replaced the value you have defined to
the permitted lowest value.
The value you have defined is higher than permissible
(High Limit)
The instrument has replaced the value you have defined to
the permitted highest value.
.
Exit from the menu, returning to the normal operating
mode (Exit)
Saving the changed parameters is being done (Save)
(4 lines at the bottom of
the display)
Low numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit” to the display
format.
(4 lines at the top of the
display)
High numerical value, not possible to display
This mnemonic is displayed in that case when you have
switched the display mode from four-and-a-half-digit to
three-and-a-half-digit, and the numerical value of a
previously defined parameter does not „fit” to the display
format.
The instrument is performing internal operations (Busy)
The requested task has been successfully completed
(Ready)
The device is preparing for the measurement.
I do not want this menu item (No)
Yes, the menu item may be started (Yes)
To Next Page
Loading...