DT9502
20171205-V3
69
Access is possible
by supervisor code only
Changing the Supervisor Code (Supervisor Code)
The new Supervisor Code must be typed in twice, in order
to avoid any typing errors. The mnemonic
(Re-
Type) warns you to type the code for the second time, after
you have typed it once. If the two codes are not identical
with each other, the mnemonic
(Bad Code) appears
on the display, and the instrument exits the menu item.
Make sure not to forget the Supervisor Code, otherwise a
new one can be defined in the service only. [Default factory
setting: 100]
Access is possible
by supervisor code only
Display mode (LCD)
• : four-and-a-half-digit mode (-19999 - 19999).
• : three-and-a-half-digit mode (-1999 - 1999).
[Default factory setting: four-and-a-half-digit]
Access is possible
by supervisor code only
Disable displaying leader zeros (Leader Null)
• : the leader zeros are displayed
• (Space): the leader zeros are not displayed, only
one standing before the integer [Default factory setting:
leader zeros are displayed]
Access is possible
by supervisor code only
Erase of min. / max. value (Reset Min. & max.)
choosing erases min. and max. values
Access is possible
by supervisor code only
Restoring the default settings (Reset 1)
When you select
, all the parameters will be reset to
the default factory setting, and the instrument restarts.
It is not possible to withdraw this command subsequently!
To Next Page
Loading...