Datcon DT9502 - Setting-up; Typing the Code (Password)

DT9502
26 20171205-V3
7. 7. Setting-up
7.1. Typing the code (password) in
The importance of the
code
You may enter the menu only after you have typed your
code in. The code is made from 3 numeric characters. This
solution prevents unauthorised persons from changing the
settings of the instrument.
Levels of authorisation
• User level: allows the modification of the most necessary
parameters only. The rest of the menu is not even shown
for users. The user code default factory setting is: 000.
• Supervisor level: allows the modification of all
parameters for the authorised person. The supervisor code
default factory setting is: 100.
Typing the code in
1. Press the MENU button. The blinking
 mnemonic
shows that the device is asking for the code.
2. Three zeros appear:
. The zero at the left side is
blinking.
• Pressing the
▲ button you can increase the value of the
blinking number:
,,,,,,,,,, etc.
• Pressing the ► button to select the next digit.
3. Pressing the
▲ and the ► buttons, type in either the user
code or the supervisor code.
4. Press the MENU button. If a correct code has been type
in, the mnemonic
 (login as a user) or the
mnemonic
 (login as a supervisor) is displayed and
stays there for 2.5 seconds; then the first menu item is
shown on the display:
.
5. If an incorrect code has been typing in, the mnemonic
 (BAD Code) is shown on the display and stays
there for 2.5 seconds; then the instrument exits from the
menu, and goes on with the measurement.
Start typing the code in again from Point 1.