DT9502
30 20171205-V3
Sequence of operations
•: Always on (ON)
It always displays the states of limit outputs.
If you keep the ENTER button pressed down, the
measurement results are displayed.
(This operating mode is useful when the states of limit
outputs is more important than the measured value.)
Exit from the menu item 1. After finishing the settings, press the MENU button to exit
from the given menu item, and you see:
.
(2. If you want to change the settings you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 2 of the Sequence of
operations.)
(3. If you don’t want to exit the menu (you want to do further
settings), then you may select the desired menu items by
pressing the ▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
(Exit) are shown on the
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
To Next Page
Loading...