DT9502
72 20171205-V3
Setting the temperature
value that belongs to 20
mA
1. Keep stepping with the ▲ button as long as you see this
menu item:
.
2. Enter this menu item by using the ENTER button.
3. By the ▲ button you may increase the value of the
blinking digit.
4. By the ► button you may step to the next digit.
5. Set the value:
.
6. Press the MENU button. With this you leave the menu
item, and you see this:
.
Disabling the leader
nulls
1. Keep stepping with the ▲ button as long as you see this
menu item:
.
2. Enter this menu item by using the ENTER button.
3. The text
is visible on the display. The text is
blinking.
4. Use the ▲ button to switch to the text:
.
5. Press the MENU button. With this you leave the menu
item, and you see this:
.
Exit the menu
Press the MENU button. First the mnemonic
(Save),
then the mnemonic
(Exit) is displayed. With this the
storing of the settings is completed. The instrument has
exited the menu and goes on with the measurement.
To Next Page
Loading...