DP-50 / DP-50D / MP55-B - USERS MANUAL
EU - the name of the alternative currency if its usage is enabled.
When the choice is made a payment is performed.
The number entered for alternative currency should be not less than the amount
outstanding, calculated in this currency. If the customer pays more than the
outstanding amount, a dialog message will appear for choosing the currency for
change. The operator can show to the customer the outstanding amount by alternate
switching with the key
.
A mixed payment is allowed. When a part of all amount is entered and a key
for payment is pressed this partial amount and the payment type are printed, and on
the display is shown the remaining part of outstanding amount. The receipt can be
closed also with other kind of payment. The payment with alternative currency is
always the last payment.
Additional function:
The key is used to start a receipt copy. For this purpose, the key must be pressed
immediately after finishing the original receipt.
1. The pressing of this key will cause adding a percentage surcharge to the
amount of the last sale or if the key
is prior pressed - it adds percentage
surcharge to the subtotal.
2. If there is no customer receipt open, this key able service entered amounts
This can be done by entering the amount value and pressing
.
The percentage value can be in the range 00.00 to 99.99.
3. It able an item with a higher PLC-code and allowable tax group to be
accessed (look at "Specific cases of operation in 'Registering' mode)
1. The pressing of this key will cause subtracting of a percentage discount
from the amount of the last sale or if the key
is prior pressed - it subtracts
percentage discharge from the subtotal.
2. If there is no customer receipt open, this key able service amounts to be
taken out. This can be done by entering the amount value and pressing
.
The percentage value can be in the range 00.00 to 99.99.
3. It able an item with a lower PLC-code and allowable tax group to be
accessed (look at "Specific cases of operation in 'Registering' mode)
Only for MP-55B
On the payment stage - after entering the amount, the pressing of this key is equal
to payment with alternative currency similar to (CRD,3) which is already explained
for DP-50 / DP-50D
When any of the working registers overflows, the operations are
possible only after report and clearing of the ECR. If the multiplication result
between quantity and price is more than ten digits, it is not the multiplication is
not allowed and an error is indicated.
26
To Next Page
Loading...
