. . . . . . . . . . . . . . . . . . . .
DPP-250 User Manual Page 30
30 ESC + Switchs OFF the printer
31 ESC -
Selecting/Canceling underlining
32 ESC . Printing self test/diagnostic information
33 ESC 2 Specifying 1/6-inch line feed rate
34 ESC 3 Specifying line feed rate n/203 inches
35 ESC < Changes print direction to opposite
36 ESC = Data input control
37 ESC > Selecting print direction
38 ESC ? Reading magnetic stripe card
39 ESC @ Initializing the printer
40 ESC CAL Black mark mode sensor calibration
41 ESC D Setting horizontal tab position
42 ESC E Specifying/Canceling highlighting
43 ESC F Filling or inverting the page area in page mode
44 ESC G Specifying/Canceling highlighting
45 ESC I Specifying/Canceling Italic print
46 ESC J Printing and Paper feed n/203 inches
47 ESC L Selecting page mode
48 ESC N Reading programmed serial number
49 ESC R Selecting country
50 ESC S Specifying speed (bps) of the serial port
51 ESC T Printing short self test
52 ESC U Selecting/Canceling underlined printing
53 ESC V Selecting/Canceling printing 90°- right turned characters
54 ESC W Defining the print area in page mode
55 ESC X Specifying max printing speed
56 ESC Y Selecting intensity level
57 ESC Z Returning diagnostic information
58 ESC \ Specifying relative horizontal position
59 ESC ] Loading the default settings stored in Flash memory
60 ESC ^ Saving current settings in Flash memory
61 ESC _ Loading factory settings
62 ESC ` Reading the Battery Voltage and Thermal head temperature
To Next Page
Loading...
