EasyManua.ls Logo

DCS WO-227SS - To Use Broil

DCS WO-227SS
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Instructions
28
NOTE: During convection roast, if the oven door is open the oven will not heat.The word on may
appear in the display, but this only indicates the oven is below temperature, and will resume
normal operation when the door is closed.
Y
ou may bake, broil, convection bake, or convection roast in both ovens at the same time. If the oven
is set to an operating temperature less than 200
0
F, then during preheat the hidden bake, hidden con-
vection, and outer broil elements will operate, as will the convection motor. After preheat only the hid-
den convection element, hidden bake element, and convection motor are used.
If the oven is set to an operating temperature of 200
0
F or more, then during and after preheat, the
hidden convection element, inner and outer broil elements will operate, as will the convection motor.
The oven cooling motors may come on and go off automatically when in convection roast.
TO USE BROIL
Position rack on number 4 or 5 rack position near broil element, position 6 is not rec-
ommended for the best results. Place food in oven on broil pan and remember you
must leave oven door open to Broil Stop position during broiling or the oven will cycle
off. No need to preheat. Standard BROIL mode uses the inner and outer broil heating
elements.
1) Press upper or lower oven BROIL.
2) Press any number key and HI will be displayed where you usually see the temperature digits.You
may leave it on HI or set at any temperature from 100
0
to 550
0
F. (High is 550
0
F. )
3) The word ON will be displayed whenever the oven is heating. When in BROIL the oven cooling
motors will come on immediately.
COOLING
FAN
VENTS
DURING BROIL
CONCEALED
BROIL
ELEMENT

Other manuals for DCS WO-227SS

Related product manuals