DeFelsko PosiTector SST User Manual

8
Setup Menu
Allows the operator to change the displayed units for both Temperature (°C or °F) and Surface
Density (mg/m
2
or µg/cm
2
)
Reset (menu Reset) restores factory settings and returns the Gage to a known condition.
The following occurs:
- All batches, stored measurements, batch names and screen captures are erased.
- Calibration adjustments are returned to factory settings.
- The last stored background measurement (γ
1
) is erased.
- Menu settings are returned to the following:
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the (+) and center buttons until the Reset symbol
appears.
This returns the Gage to a known, “out-of-the-box” condition.
It performs the same function as a menu Reset with the addition of:
- Bluetooth Pairing info is cleared.
- Menu settings are returned to the following status:
NOTE: Date, Time and WiFi settings are not affected by either Reset.
Displays the model number & serial number, probe type & serial number, PosiSoft.net registration
key, the amount of remaining memory for storage of readings, date and time, and software
packages.
For security purposes, the registration key is required to add the instrument to your free
PosiSoft.net account.
Memory = OFF
Bluetooth & Stream = OFF
Bresle Mode = ON
WiFi & Access Point = OFF
Auto Dim = ON
Surface Density units = mg/m
2
Display = None
Temperature units = °C
Patch Volume = 3.0ml
Hi Res = OFF
Flip Display = Normal
Language = English
Backlight = Normal
Battery Type = Alkaline
Auto Sync .net = ON
Bluetooth Smart = OFF
White on Black = ON
USB Drive= ON
Sound = ON
Units
Reset
Gage Info

DeFelsko PosiTector SST Specifications

General

Brand	DeFelsko
Model	PosiTector SST
Category	Measuring Instruments
Language	English