Gage functions are menu controlled. To access the Menu, power-up the gage, then press the
center navigation button. Below is a sample menu for a PosiTector Advanced Model:
To navigate, use the Up and Down buttons to scroll vertically and to SELECT.
Press the (+) button to switch pages
Press the (-) button to return to the
Select Exit to exit from any menu.
When powered-up, the PosiTector automatically determines which probe is
attached and does a self-check.
To disconnect a probe from a body, slide the plastic probe connector horizontally
(in the direction of the arrow) away from the body. Reverse these steps to attach a
different probe. It is not necessary to power-down the Gage when switching probes.
The PosiTector gage body accepts a wide variety of probe types including magnetic, eddy-
current and ultrasonic coating thickness, surface profile, environmental, Shore hardness
durometer and ultrasonic wall thickness probes. See www.defelsko.com/probes
PosiTector SST probes consist of a purpose-built test cell, optimized for
the range, resolution and test volume of the Bresle Method. Conductivity
measurements are compensated to 25°C (77°F) using a built-in
temperature sensor, and the sample temperature is recorded for each
measurement. The probe can be used as a conventional conductivity meter
by unchecking Bresle Mode (pg. 9).
To Next Page
Loading...
Need help?
General
