The below WiFi, USB and Bluetooth menus contain a Sync .net Now option. When selected,
the Gage immediately synchronizes stored measurement data via its respective communication
method (internet connection required).
Alternatively, select Auto Sync .net from within the USB connect menu to automatically
synchronize upon connection to a PC. Additional measurements added to memory while
connected are synchronized only when the USB cable is disconnected and reconnected, or
when the Sync .net Now option is selected.
(Advanced models only, serial numbers 784000 and greater)
Turns Bluetooth functionality ON. When selected, the icon will appear on the display.
To deactivate WiFi, uncheck the Enable box.
When Enabled
, allows communication with a smart device running the PosiTector App
(
pg. 12) via auto-
pairing Bluetooth Smart (BLE) wireless technology.
Select batches to flag them for synchronization to the PosiTector App. New batches created
while Bluetooth Smart is enabled are automatically selected.
With Bluetooth Smart enabled, select Sync Batches to transfer
selected batches to the
PosiTector App. This is useful when
switching between smart devices, as only readings and
batches that have yet to be synchronized with any smart device are synchronized automatically.
NOTE: If Bluetooth Smart is disabled, data from batches selected in the Sync Batches menu
are held in a queue until communication with the PosiTector App is re-established.
Transfers selected batches to the PosiTector App (useful when switching between devices).
The Send Batches option is visible in the Bluetooth Smart menu when the Gage is connected to
a smart device running the PosiTector App.
To Next Page
Loading...
