Selects the type of batteries used in the Gage from a choice of “Alkaline”, “Lithium” or “NiMH”
(nickel-metal hydride rechargeable). If “NiMH” is selected, the Gage will trickle charge the
batteries while connected via USB to a PC or optional AC power supply (USBAC). The battery
state indicator symbol is calibrated for the selected battery type. No damage will occur if the
measurements can be reviewed on- screen or accessed via computers, tablets and smart
phones. All stored measurements are date and time-stamped.
The symbol appears and basic statistics are displayed when the Gage is set to store
Press both (-) (+) buttons at any time to capture and save an image copy of the current display.
The last 10 screen captures are stored in memory and can be accessed when connected to a
computer (see PosiSoft USB Drive, pg. 12).
Standard models store up to 250 readings in one batch.
The Memory menu includes the following options:
On: turns memory on and begins recording
Off: stops recording (stored readings remain in memory)
Clear: removes all readings from memory
View: lists group statistics and all stored readings on the display. It will begin by showing
statistics based on all readings in memory. Use the Up and Down buttons to scroll through all
readings. Press to exit.
Advanced models store 100,000 readings in up to 1,000 batches.
The Memory menu includes the following options:
Closes any currently opened batch and creates a new batch name using the lowest available
number. For example, if only Batch 1 and Batch 3 exist, then Batch 2 would be created and
made the current batch. Each measurement will be displayed and stored into this new batch. New
batch names are date stamped at the time they are created.
NOTE:
* Calibration adjustments cannot be made if readings are stored in memory.
To Next Page
Loading...
Need help?
General
