D E H L E R 3 4
The means of reboarding shall be permanently deployed if the craft is used singlehanded,
whether anchored, moored, stationary or under way.
One should furthermore take precautions to comply with the "rules of good seamanship" (lifebelt,
life lines, connecting belt as short as possible ...).
To install the reboarding ladder:
1. Cow hitch the reboarding
ladder around the pushpit.
The loop of ladder needs to
face outboard.
2. Pass the flap of the case
between the loop of the
cow hitch and the top step.
3. Screw the flap to the case
with the two screws and
nuts.
The nuts should be facing
the outside of the case.
4. Test the ladder to be sure it
falls correctly in the water.
It is important to ensure
that the ladder deploys
safely into the water.
Finally, fold the ladder back
into its case and close the
flap with snaps.
Your rescue ladder is
ready.
The cord should be cut flush with the waterline to
avoid the risk that it will get caught in the
propeller.
It must remain in position, accessible from the
water when the boat is sailing.
To Next Page
Loading...
