D E H L E R 3 4
2.6. Manoeuvring by engine
Pay attention to the recommendations in the engine operation manual.
• Switch on the main switch.
• Check whether the single-lever control is in neutral position.
• Begin the start procedure.
• In case the engine does not start, repeat the start procedure after a short pause.
• If the engine does not start after the third try, please check the reason.
After the successful start of the engine and all systems were checked, e.g. the cooling system,
you can start the first trial. Pay attention to the direction of rotation of the propellers and
manoeuvre carefully.
Practise the man-over-board manoeuvre and the anchoring regularly.
2.7. Checking the systems
On principle, the boat is delivered in working order, if not otherwise agreed upon. We attempt to
convey the necessary knowledge and special features to you when delivering the boat.
After Launching and rigging, it is necessary to do a complete leak
test from all skin fitting ,keel fittings and the sail drive bearing.
Be sure that the fuel and water tanks are full and the boat has full
displacement.
Before you start the systems the first time, you should check all systems on board step by step.
Use this safety manual and the operation manual of the boat. You will learn where the different
devices and appliances are located and their operation.
Repeat this checks if you have do not used the boat over a longer time, especially before the new
water sports season starts.
To Next Page
Loading...
