• Setup menu: Displays a different value in the second line.
• A parameter: Increases the set point.
4. Selects the underscored entry in the fourth line of the display.
5. Moves the cursor right.
6. Down button: Function depends on context.
• V1: Scrolls the view lines.
• Setup menu: Displays a different value in the second line.
• A parameter: Decreases the set point.
7. Changes the menu line (line four) in the display to mode selection.
• Not present in group and plant controllers.
8. Jumps one step backwards in the menu (to previous display or to the entry window).
9. Displays the LOG SETUP window where you can choose between the Event, Alarm and Battery logs. The logs are not deleted
when the auxiliary supply is switched off.
10. Manual activation of close/open breaker sequence if SEMI is selected.
11. Manual activation of close/open breaker sequence if SEMI is selected.
12. Stops the genset/plant if SEMI or MANUAL* is selected.
13. Starts the genset/plant if SEMI or MANUAL* is selected.
14. Enables the user to use the menu number to select and display any setting.
15. Shifts the display three lower lines to show the alarm list. By holding the button, all alarms will be acknowledged.
16. Group and plant controllers: Select AUTO and SEMI mode.
17. German AGC only: Test button.
*Note: MANUAL mode is not available in German controllers.
OPERATOR'S MANUAL 4189340690E EN Page 9 of 24