DeLaval MA200 - 2.2.1 Technical data; 2.3 Junction box

Preliminary
941322_VMS Instruction Book 2006.pdf2009-09-07
No. Name Range Default Description/optionsNo. Name Range Default Description/options
0 = no acidic cleaning0 = no acidic cleaning
1 = one alkaline, one acidic cleaning1 = one alkaline, one acidic cleaning
2 = two alkaline, one acidic cleaning2 = two alkaline, one acidic cleaning
3 = etc.3 = etc.
Maintenance an calibration
The following points are important to sustain
correct dosing of etergents. Note that
these two tasks should be performed by an
authorised DeLaval service engineer.
• The tubes in the peristaltic pumps should
be replaced at least two times a year.
• The dosing volume (P6-P8) of the
detergent pumps should be checked
every third month. The dosing capacity
(P32-P34) may need to be adjusted.
Starting cleaning or rinsing
from the touch screen
Note: Any ongoing backflush process must
first be finished before cleaning or rinsing
can be started.
1. Ensure that the milking station is in
manual mode.
2. Remove any cow that might be in the
milking station.
After treatment window
Note: Both gates should be closed to
prevent a cow from entering before the
system cleaning has been started. Closing
and opening gates is done in the Stall
control window.
3. Press the tab After Treatment on the
touch screen to display the After treatment
window.
4. In the After treatment window, press the
Cleaning and Rinsing button. This will open
the Cleaning and rinsing window.
2.2.1 Technical data
Infrastructure box
Main dimensions
Length X mm
Width Y mm
Height Z mm
Power supply
Protection class
Bluetooth
Frequency range
Channel bandwidth
Maximum rated output power EIRP
Operation temperature
Operation temperature
Ambient temperature in barn
Weight
Net
Bracket net weight
Gross (packing included)
2.3 Junction box
On rotary milking point automation panels the
junction box is a connection terminal between the
input/output module and the button module, com-
fort start (CS) equipment and air wash (AW)
equipment. In the milking automation network the
junction boxes on the automation panels con-
nects the input/output modules in the automation
panel groups of three together. Every group of
three automation panels are connected to one of
the five bus connections in a communication and
control module.
275620
Fig. 9: Junction box.
DeLaval milking automation MA200 (Test installation)
General description
© DeLaval 2019.
2019-05-31, Version 1 33 (62)