Delem DAC-310 - Page 32

Delem
V1204, 2.21
Parameter 35:
Unipolar output
Range : 0 - 1
Unit : -
Default : 0
Function
Function to switch unipolar AC control on/off. When set to 1, the analog speed output will
only output a positive signal, no matter which direction the axis is moving. This can be used
to connect a frequency regulator for 1 or 2-speed AC control. See also section 2.3 about AC
drives.
Parameter 40:
Servo gain
Range : 1 - 15
Unit : -
Default : 8
Function
Position gain factor. See also section 2.3.
Parameter 41:
Servo switch
Range : 0 - 999
Unit : count pulses
Default : 20
Function
Switching point from Ramp to gain. See also section 2.3.
Parameter 42:
Servo ramp
Range : 1 - 15
Unit : -
Default : 6
Function
Servo axis braking factor. See also section 2.3.