The following table lists the special port for DLm8500 with Data Domain replication:
Table 6 Required Network Port for DLm8500 DD Replication
Port Number Port Type Traffic User Direction of
Traffic
Notes
2051 TCP Data Domain
replication
Inbound/
Outbound
Proprietary
protocol
Network software ports needed to support DLm debugging operations
This section describes about the requirement of network software ports needed to
support DLm debugging operations.
Network ports are required to connect the DLm and the SRS gateways.
Note: If you need to resolve errors, before continuing, you must contact Dell EMC
Support for assistance to determine which port to open.
The following table provides a list of required network ports to connect the DLm and
the SRS gateways.
Table 7 Required Network Ports for DLm debugging Operations
Port
Number
Port Type Protocol(s
)
Traffic User Direction of
Traffic
Notes
20 TCP FTP Data Outbound To/From SRS
21 TCP FTP Command/
Control
Inbound/
Outbound
To/From SRS
22 TCP SSH/SCP Secure Shell/
Secure Copy
Inbound/
Outbound
To/From SRS
9443 TCP TCP GUI/
Communicatio
n
Outbound To SRS
DLm8500 Physical Data Requirements
This section provides an overview of physical data requirements.
A DLm8500 Single Rack Solution weighs 1329 lb (603 kg).
DLm8500 Multiple Rack Solution has a maximum configuration of one VTEC cabinet
and two DD6800, DD9300, or DD9800 cabinets.
When fully configured, the weight of each cabinet is:
l
VTEC cabinet—1,060 lb (480.81 kg)
l
Data Domain cabinet—1,366 lb (619.61 kg)
l
DD storage cabinet—1225 lb (556.82 kg)
Note:
All weight values are calculated for a fully loaded configuration. Contact
your Dell EMC Sales Representative for specific supported configurations.
Despite the differences in weight, the physical dimensions of all the cabinets are the
same.
The following table lists the physical specifications for DLm cabinets:
DLm8500 with Data Domain Physical Planning
30 Disk Library for mainframe Physical Planning Guide for DLm8500
To Next Page
Loading...
