CAUTION: The sideplanes on the enclosure drawers are not hot swappable or customer serviceable.
Safety features
• To prevent the rack from tipping, slide only one enclosure out of the rack at a time.
• The drawer locks into place when fully opened and extended. To reduce finger pinching hazards, two latches must be released before
the drawer can be pushed back into the drawer slot within the enclosure.
Each drawer can be locked shut by turning both anti-tamper locks clockwise using a screwdriver with a Torx T20 bit (included in your
shipment). The anti-tamper locks are symmetrically placed on the left and right sides of the drawer bezel. Drawer status and activity LEDs
can be monitored by two drawer LEDs panels located next to the two drawer-pull pockets located on the left and right side of each
drawer.
Figure 27. Drawer bezel details
1.
Left side 2. Right side
3. Anti-tamper lock 4. Sideplane OK/Power Good
5. Drawer fault 6. Logical fault
7. Cable fault 8. Drawer activity
9. Drawer pull handle
NOTE: For descriptions of drawer LED behavior, see Table 18. Drawer LED descriptions.
Operator's (Ops) panel LEDs
Each ME4 Series enclosure features an Ops panel located on the chassis left ear flange. This section describes the Ops panel for 2U and
5U enclosures.
2U enclosure Ops panel
The front of the enclosure has an Ops panel located on the left ear flange of the 2U chassis. The Ops panel is an integral part of the
enclosure chassis, but is not replaceable on site.
Figure 28. LEDs: Ops panel—2U enclosure front panel
Storage system hardware
19
To Next Page
Loading...
