Option Description
• Always
• Never
Date/Time Allows you to set the date and time.
NOTE: The changes to the system date and time takes effect immediately.
Table 3. System configuration
Option Description
Integrated NIC Allows you to configure the on-board LAN controller.
• Enable UEFI Network Stack
• Disabled
• Enabled
• Enabled w/PXE (Default setting)
Serial Port Identifies and defines the serial port settings. You can set the serial port to:
• Disabled
• COM1 (Default setting)
• COM2
• COM3
• COM4
SATA Operation Allows you to configure the internal SATA hard-drive controller.
• Disabled
• AHCI
• RAID On (Default setting)
Drives Allows you to configure the SATA drives on board.
• SATA-0
• SATA-1
• SATA-2
• SATA-3
Default setting: All drives are enabled.
SMART Reporting This field controls if the hard drive errors for the integrated drives are reported during system
startup. This technology is part of the SMART (Self Monitoring Analysis and Reporting
Technology) specification.
• Enable SMART Reporting (Default setting: not enabled)
USB Configuration Allows you to enable or disable the USB configuration.
• Enable USB Boot Support (Default setting)
• Enable Front USB Ports (Default setting)
• Enable rear USB Ports (Default setting)
Front USB Configuration Allows you to enable or disable the front USB configuration.
• Front Port 1 (Left)
• Front Port 2 (Center)
• Front Port 3 (Right)*
• Front Port 4 (Type C)*
*Denotes a USB 3.0–capable port
Rear USB Configuration Allows you to enable or disable the rear USB configuration.
• Rear Port 1 (Upper Left)
• Rear Port 2 (Upper Right)
• Rear Port 3 (Left)*
18 Pre-operating system management applications
To Next Page
Loading...
