Dell EMC PowerEdge T40 - Memory Map IO above 4 GB; Audio; Miscellaneous devices; Video

Option Description
• Rear Port 4 (Center Left)*
• Rear Port 5 (Center Right)*
• Rear Port 6 (Right)*
*Denotes a USB 3.1 Gen 1–capable port
Memory Map IO above 4 GB Allows you to enable or disable memory mapping IO above 4 GB.
The option is enabled by Default setting.
Audio Allows you enable or disable the audio feature.
• Enable Audio(Default setting)
• Enable Internal Speaker (Default setting)
Miscellaneous devices Allows you to enable or disable various on-board devices.
• Enable PCI Slot (Default setting)
Table 4. Video
Option Description
Multi-Display
NOTE: The processor must
be Intel Graphic Device
(IGD) capable to view this
option.
NOTE: Ensure to install an
additional GPU to utilize this
option.
Allows you to enable or disable multi display feature.
Default setting: not enabled.
Primary Display Allows you to configure primary video controller when there are multiple controllers available.
• Auto (Default setting)
• Intel HD Graphics
Table 5. Security
Option Description
Admin Password This option allows you to enable or disable admin passwords for the system (Default setting: not
enabled).
System Password This option allows you to enable or disable system passwords for the system (Default setting: not
enabled).
Strong Password This option allows you to enable or disable strong passwords for the system (Default setting: not
enabled).
Password Configuration Allows you to control the minimum and maximum number of characters allowed for a administrative
password and the system password. The range of characters is between 4 and 32.
Password Bypass This option lets you bypass the system (Boot) password and the internal HDD password prompts
during a system restart.
• Disabled — Always prompt for the system and internal HDD password when they are set. This
option is enabled by Default setting.
• Reboot Bypass — Bypass the password prompts on Restarts (warm boots).
NOTE: The system will always prompt for the system and internal HDD passwords
when powered on from the off state (a cold boot). Also, the system will always prompt
for passwords on any module bay HDDs that may be present.
Password Change This option allows you to determine whether changes to the System and Hard Disk passwords are
permitted when an administrator password is set.
Pre-operating system management applications 19