Back to Contents Page
Faxing
FAX Country Setting
Setting the Printer ID
Using the Number Keypad to Enter Characters
Setting the Time and Date
Changing the Clock Mode
Setting Sounds
Specifying the Fax Settings
Sending a Fax
Sending a Delayed Fax
Sending a Fax from the Driver (Direct Fax)
Receiving a Fax
Automatic Dialing
Other Ways to Fax
Printing a Report
Changing Setting Options
FAX Country Setting
The FAX country setting is used to set the country where your printer is used. This is a requirement for using the FAX service on the printer.
There are two ways to set the country settings:
l Fax Initial Setup - a part of the installation software
l Printer operator panel - follow "FAX Country Setting Procedure"
You will have to use the operator panel and follow the instructions below, if:
l You purchased your printer with a new Dell computer
l You have finished Windows Installer setup without completing FAX Initial Setup
l You wish to change the country settings of where your printer is used
FAX Country Setting Procedure
To set the country settings from the printer operator panel:
1. Press until >SETUP appears, and then press .
2. Press until >Admin Menu appears, and then press .
3. Press until >Fax Settings appears, and then press .
4. Press until >Country appears, and then press .
5. Select the country where the printer is used.
The printer must be rebooted after you set the country settings. When a message prompting you to reboot the printer appears, select Yes. After the reboot,
the top menu is displayed on the operator panel.
6. Press until >SETUP appears, and then press .
7. Press until >Admin Menu appears, and then press .
8. Press until >System Settings appears, and then press .
9. Press until >Clock Settings appears, and then press .
To Next Page
Loading...
