Steps
1. Align the screw hole on the solid-state drive bracket with the screw hole on the palm-rest and keyboard assembly.
2. Replace the screw (M2x4) that secures the solid-state drive bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the
2230 solid-state drive or 2280 solid-state drive, as applicable.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image(s) indicate the location of the touchpad and provides a visual representation of the removal procedure.
36
To Next Page
Loading...
