Option Description
• Enable Legacy Option ROMs
(Default)
Date/Time Allows you to set the date and time. The
changes to the system date and time
takes effect immediately.
Table 3. System Configuration
Option Description
Integrated NIC Allows you to configure the integrated network controller. The
options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active
Management Technology (AMT) option is disabled.
• Enabled
• Enabled w/PXE (Default)
Integrated NIC 2 Allows you to configure the
integrated network controller. The
options are:
• Enabled (Default)
• Enabled w/PXE
NOTE: This feature is supported
only on Tower 7910.
Serial Port Identifies and defines the serial port settings. You can set the
serial port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if
the setting is disabled.
SATA Operation
Tower 5810 and Tower 7810
Allows you to configure the internal
SATA hard-drive controller. The
options are:
• Disabled
• ATA
• AHCI
• RAID On (Default)
45
To Next Page
Loading...
Need help?
General
