Installing the power supply unit PSU
1. Insert the PSU into the PSU slot and slide it toward the back of the computer until it clicks into place.
2. Tighten the 6-32xL6.35 screws to secure the PSU to the computer.
3. Route the PSU cables through the retention tabs.
4. Connect the PSU cables to the connectors on the system board.
5. Close the front panel door.
6. Install the:
a. bezel
b. cover
7. Follow the procedure in After working inside your computer.
Power switch
Removing the power switch
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. bezel
3. Open the front panel door.
4. To remove the power switch:
a. Disconnect the power switch cable from the system board [1].
b. Press the release tabs [2] and slide the power switch out from the front of the computer [3].
NOTE:
It is recommended to move aside the power cables connected to the system board or disconnect the power
cables from the system board.
Disassembly and reassembly 17
To Next Page
Loading...
