Dell D19M - System Configuration Screen Options

Option Description
● Secure Digital (SD) Card Boot
System Configuration screen options
Option Description
Primary display This field determines which video controller is the primary display when multiple controllers are available
in the system. If you select a device other than what you are currently using, you need to reconnect your
video cable to your selected device.
NOTE: When Auto is not selected, the onboard graphics device will be present and enabled.
The options are:
● Auto - Enabled by default
● Intel HD Graphics
Security screen options
Option
Description
Admin Password Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard drive password. Deleting
the admin password automatically deletes the system password and the hard drive password.
NOTE: Successful password changes take effect immediately.
Default setting: Not set
System
Password
Allows you to set, change or delete the system password.
NOTE: Successful password changes take effect immediately.
Default setting: Not set
Internal HDD-0
Password
Allows you to set, change or delete the system’s internal hard disk’s password.
Default setting: Not set
NOTE: Successful password changes take effect immediately.
Strong Password Allows you to enforce the option to always set strong passwords.
Default Setting: Enable Strong Password is not selected.
NOTE: If Strong Password is enabled, Admin and System passwords must contain at least one
uppercase character, one lowercase character and be at least 8 characters long.
Password
Configuration
Allows you to determine the minimum and maximum length of Administrator and System passwords.
Password Bypass Allows you to enable or disable the permission to bypass the System and the Internal HDD password,
when they are set. The options are:
● Disabled
● Reboot bypass
Default setting: Disabled
Password
Change
Allows you to enable the disable permission to the System and Hard Drive passwords when the admin
password is set.
Default setting: Allow Non-Admin Password Changes is selected.
System Setup Options 47