Installing the power switch
1. Insert the power switch into the slot from the front of the computer and press it until it clicks into place.
2. Align the cable with the pins on the connector and connect the cable.
3. Close the front panel door.
4. Install the:
a. bezel
b. cover
5. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin cell battery
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. cover
b. bezel
3. Open the front panel door.
4. To remove the coin cell battery:
a. Press the release latch until the coin cell battery pops out.
b. Remove the coin cell battery from the connector on the system board.
Installing the coin cell battery
1. Hold the coin cell battery with the "+" sign facing up and slide it under the securing tabs at the positive side of the
connector.
18
Disassembly and reassembly
To Next Page
Loading...
