Dell E2225H - Product Features

About your monitor 7
Product features
The Dell E2225H/E2425H flat panel monitor has an active matrix, Thin-Film Transistor (TFT), Liquid Crystal Display (LCD) panel with LED
backlight. The monitor features include:
• E2225H: 544.85 mm (21.45 in.) viewable area display (measured diagonally). 1920 x 1080 resolution, with full-screen support for lower
resolutions.
• E2425H: 604.70 mm (23.81 in.) viewable area display (measured diagonally). 1920 x 1080 resolution, with full-screen support for lower
resolutions.
• Wide viewing angle of 178 degrees in vertical and horizontal directions.
• Contrast ratio (3000:1).
• Digital connectivity with DisplayPort.
• Support FHD @ 75 Hz.
• Plug and play capable if supported by your computer.
• On-Screen Display (OSD) adjustments for easy setup and screen optimization.
• ≤ 0.3 W in Standby mode.
• Optimize eye comfort with a flicker-free screen.
• Security-lock slot.
• Arsenic-free glass and Mercury-free panel only.
• BFR/PVC-Reduced (Its circuit boards are made from BFR/PVC-free laminates).
• Meets NFPA 99 leakage current requirement.
• TCO Certified and TCO Certified Edge.
• EPEAT registered where applicable, varies by country.
See https://www.epeat.net for registration status by country.
• RoHS Compliant.
• Energy Star Certified.
• Dell ComfortView Plus is an integrated low blue light screen feature that improves eye comfort by reducing potentially harmful blue
light emissions without compromising color. Through ComfortView Plus technology, Dell has reduced harmful blue light exposure from
50% to 35%. This monitor is certified with TÜV Rheinland Eye Comfort 3.0 with a 3-star rating. It incorporates key technologies that
also deliver a flicker-free screen, up to 75 Hz refresh rate, a color gamut of minimum 95% sRGB. Dell ComfortView Plus feature is
enabled by default on your monitor.
• This monitor uses a low blue light panel. When the monitor is reset to factory settings or default setting, it is in compliance with TÜV
Rheinland’s hardware low blue light certification.*
*This monitor is in compliance with TÜV Rheinland hardware low blue light certification under Category 3.
Blue light ratio:
The ratio of light in the range from 415nm-455nm compared to 400nm-500nm shall be less than 50%.
Table 2. Blue light ratio.
Category Blue light ratio
1
< 20%
2
20% < R < 35%
3
35% < R < 50%
• Decreases the level of hazard blue light emitted from the screen to make viewing more comfortable for your eyes without distortion of
color accuracy.
• The monitor adopts Flicker-Free technology, which clears the eye visible flicker, brings comfort viewing experience and preventing
users suffer from eye strain and fatigue.