Figure 10. Removing and installing the hard drive cage
1. hard drive cage latch 2. hard drive cage guide screw (2)
3. hard drive cage
Next steps
1. Install the hard drive cage.
2. If disconnected, connect the power and data cables to the hard drives and the optical drive in the
hard drive cage.
3. Install the bezel.
4. Reconnect the peripherals disconnected from the control panel assembly.
5. Follow the procedure listed in After working inside your system.
Related Tasks
Removing the bezel
Installing the hard drive cage
Installing the bezel
Installing the hard drive cage
Prerequisites
1. Ensure that you follow the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Disconnect all peripherals connected to the control panel assembly.
49
To Next Page
Loading...
