2. Follow the procedure listed in Before working inside your system.
3. Disconnect all peripherals connected to the I/O module.
4. Remove the bezel.
5. If connected, disconnect the power and data cables from the optical drive and hard drives.
6. Remove the hard drive cage.
Steps
Press down and push the blue release tab and push the optical drive out of the hard drive cage.
Figure 18. Removing and installing the optical drive
1. SATA and power cable 2. release tab
3. optical drive 4. hard drive cage
Next steps
1. Install the optical drive.
2. Install the hard drive cage.
3. Reconnect the disconnected data and power cables to the hard drives and optical drive.
4. Install the bezel.
5. Reconnect the peripherals disconnected from the control panel assembly.
6. Follow the procedure listed in After working inside your system.
Related Tasks
Removing the bezel
Removing the hard drive cage
Installing the optical drive
Installing the hard drive cage
Installing the bezel
61
To Next Page
Loading...
